Skip to content
Product Image Bulli SM

Bulli for masts and cages

Bulli protects your cables on metal masts and in cages.

Thieves normally short-circuit the cable they want to steal, cut it on both ends and pull out the whole length.

  1. The Bulli system anchors the cable so that it is impossible to easily remove the whole length of cable as before. The system inhibits horizontal movement to prevent pulling the cable out sideways to prevent upward pulling of the cable.
  2. Not being able to pull out the cable, the thieves are now reduced to cutting the cable at every anchor.
  3. The time taken to steal the cable now exponentially increases the thieves’ chances of getting caught.

The Bulli installation steps for masts and cages

The Bulli  installation process is easy and can be done with unskillled labour

Drill the
holes

Bulli SC Installation1

Drill 4 x 10mm holes at the installation position using the cable saddle holes as a guide.

Position
the bushes and saddle

Bulli SC Installation2

Position the bushes around the cable and place the cable saddle over the bushes.

Insert the
bolts

Bulli SM Installation3

Insert the 4 bolts – dome side up – through the saddle holes and the metal base so that the square shoulders of the bolt engages with the slots in the saddle.

Tighten and
secure

Bulli SM Installation4

Screw the shear nuts onto the bolts and tighten them until the shear nuts snap off.
Your cable is now secure.