Skip to content
Product Image Bulli SC

Bulli for tunnels and walls

Bulli protects your cables in tunnels, on walls and on concrete ceilings and floors.

Thieves normally short-circuit the cable they want to steal, cut it on both ends and pull out the whole length.

  1. The Bulli system anchors the cable so that it is impossible to easily remove the whole length of cable as before. The system inhibits horizontal movement to prevent pulling the cable out sideways to prevent upward pulling of the cable.
  2. Not being able to pull out the cable, the thieves are now reduced to cutting the cable at every anchor.
  3. The time taken to steal the cable now exponentially increases the thieves’ chances of getting caught.

The Bulli installation steps for tunnels and walls

The Bulli  installation process is easy and can be done with unskillled labour

Drill the
holes

Bulli SC Installation1

Drill 4 x 10mm holes, 85mm deep at the installation position using the cable saddle holes as a guide.

Position bushes,
saddle and cable

Bulli SC Installation2

Position the bushes around the cable and place the cable saddle over the bushes.

Insert the
anchors

Bulli SC Installation3

Insert the 4 anchors through the saddle holes into the concrete holes drilled previously.

Tighten and
secure

Bulli SC Installation4

Tighten all 4 shear nuts until they snap off.
Your cable is now secure.